If you want the song to end naturally, it’s best to follow the remixing steps above to remove a section of the song and then move the end earlier in the project timeline.įinally, if your track is barely too long - or short, for that matter - and you want to avoid remixing, you can alternatively adjust the playback rate under “item settings” (shortcut: double-click the clip). This is a fast and easy solution but not necessarily ideal in all scenarios. You could split the clip where you want it to end and then create a fade-out. Is your audio track too long for your project? There are a few ways you can make it shorter. Got it? Up next is adjusting song length - a pretty straightforward task once you understand how to remix.
![]() Click the second clip and drag it until it meets the first.Select the now separated chorus clip and press the “delete” key.Find the exact moment the chorus ends and the following verse begins.Click the timeline at this spot and press the “s” key.Find the exact moment the chorus begins - this will likely be marked by a peak in the waveform.Let’s say you want to remove the chorus of a song. If an edit is obvious upon listening, try adjusting where the clips meet by shortening or lengthening each clip (i.e., click the edge of the clip and drag) little by little until it sounds tight.įinally, to polish and better hide the edit, create a crossfade between the clips by following the instructions above. Repeat this process as necessary, and then click and drag clips to rearrange them. When you’ve decided how you want to remix the song, split your clip by clicking the project timeline where you want to cut and pressing the “s” key. This will ensure your edits are as precise as possible. Pro tip: Make sure that your project grid (shortcut: option + l) is set to 1/128. These peaks often indicate a cymbal crash, kick drum, or other louder sound and make for an ideal place to cut. Then, once you find them, look for spikes in the waveform. First, listen for natural transitions - such as when a verse leads into a chorus. To remix, begin by using both your ears and eyes to identify the best places to split the audio track. How to remix a recordingīeyond fades, the most common changes you can make to a finished song involve remixing, which is essentially cutting up and moving around clips of audio. If you crossfade any more than that, you’ll likely end up with a muddy transition as the two arrangements compete. To fade between clips - what’s known as crossfading - grab the edge of one clip and drag it until it overlaps another just slightly. ![]() To create a fade-out in Reaper, click the top right corner of the clip and drag left. The effect can make audio transitions in your project sound smoother, as well as help hide any cuts you make when remixing, which we’ll get to shortly. If you’re not familiar, “fading” refers to a gradual increase or decrease in volume. Let’s start with one of the easiest and most fundamental customizations: the fade.
0 Comments
Leave a Reply. |
Details
AuthorRobert ArchivesCategories |